EuroLite TMH-155 Moving-Head User Manual download pdf (Page 27)

00057930.DOC, Version 1.0

27/34

Stand Alone operation

In the Stand Alone mode, the LED TMH-6 can be used without controller.

Disconnect the LED TMH-6 from the controller and call the internal program. Please refer to the instructions

nder Control Board.

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-

device.

On the rear panel of the LED TMH-6 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which

can be used for connecting several devices.

Choose the device which is to control the effects. This device then works as master device and controls all

other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX

OUT jack with the DMX IN plug of the next device.

Set the desired master-mode for the master-device and the slave-mode for all slave-devices. Please refer to

the instructions under Control Board.

DMX-controlled operation

You can control the projectors individually via your DMX-controller.

Every DMX-channel has a different occupation with different features. The individual channels and their

features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from

which the LED TMH-6 will respond to the controller.

Please, be sure that you don’t have any overlapping channels in order to control each LED TMH-6 correctly

and independently from any other fixture on the DMX-chain.

If several LED TMH-6 are addressed similarly, they will work synchronically.

Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED

TMH-6 via your lighting controller.

Note:

The modes of DMX 512 data are shown via the display:

After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data

is received, the the display will show " d001." with the actually set address. If there is no data received at the

DMX-input, the display will show " d001" with the actually set address.

This situation can occur if:

- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.

- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap

in the input connector.

Note:

It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to

ensure proper transmission on the DMX data link.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

No comments

EuroLite TMH-155 Moving-Head User Manual Page 27