EuroLite LED B-20 TCL User Manual download pdf (Page 15)

00046913.DOC, Version 1.1

15/30

IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)

alculating working load limits, installation material being used, and periodic safety inspection of all

installation material and the device. If you lack these qualifications, do not attempt the installation yourself,

but instead use a professional structural rigger. Improper installation can result in bodily injury and or

damage to property.

The device has to be installed out of the reach of people.

The device must never be fixed swinging freely in the room.

Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have

doubts concerning the safety of a possible installation, do NOT install the device!

Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's

weight.

The device must be installed in an absolutely horizontal position.

Always install the device via all fixation holes.

Do only use appropriate screws and make sure that the screws are properly connected with the ground.

DANGERTOLIFE!

Beforetakingintooperationforthefirsttime,theinstallationhastobeapprovedbyanexpert!

Procedure:

Step 1: On the baseplate, there are 4 holes for the installation.

Step 2: Hold the baseplate onto the location where the device is to be installed.

Step 3: Mark the boreholes with a pen or a suitable tool.

Step 4: Drill the holes.

Step 5: Hold the baseplate in the desired position and tighten it.

For overhead use, always install an appropriate safety bond.

You must only use safety bonds complying with DIN 56927, quick links complying with DIN 56926, shackles

complying with DIN EN 1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles and the

carbines must be sufficiently dimensioned and used correctly in accordance with the latest industrial safety

regulations (e. g. BGV C1, BGI 810-3).

Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be

followed that this manual can only give in part. The operator must therefore inform himself on the current

safety instructions and consider them.

The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety

precautions!

Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.

Insert the end in the quick link and tighten the safety screw.

The maximum drop distance must never exceed 20 cm.

A safety bond which already held the strain of a crash or which is defective must not be used again.

DANGERTOLIFE!

Beforetakingintooperationforthefirsttime,theinstallationhastobeapprovedbyanexpert!

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

No comments

EuroLite LED B-20 TCL User Manual Page 15