EuroLite Disco Strobe 50 User Manual download pdf (Page 10)

52200611_V_1_0_4946.DOC

10/23

This device falls under protection-class II and features a protective insulation.

Never let the power-cord come into contact with other cables! Handle the power-cord and all connections

with the mains with particular caution!

Make sure that the available voltage is not higher than stated on the rear panel.

Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the

power-cord from time to time.

Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the

power-cord by the plug. Never pull out the plug by tugging the power-cord.

During the initial start-up some smoke or smell may arise. This is a normal process and does not necessarily

mean that the device is defective.

HEALTH HAZARD!

Never look directly into the light source, as sensitive persons may suffer an

epileptic shock (especially meant for epileptics)!

Please consider that damages caused by manual modifications to the device are not subject to warranty.

CAUTION: Never touch the plug's contact pins! Danger of electric shock at unplugged plug.

Never operate the stroboscope without protective shield!

Replace any cracked protective shield.

Do not touch the flash tube bare-handed!

The flash tube is to be changed by qualified personnel only!

Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a lighting effect for creating decorative effects. This product is only allowed to be operated with

an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.

Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the

device will serve you for a long time without defects.

Do not shake the device. Avoid brute force when installing or operating the device.

When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,

moisture or dust. There should not be any cables lying around. You endanger your own and the safety of

others!

Do not operate the device in extremely hot (more than 45° C) or extremely cold (less than 5° C)

surroundings. Keep away from direct insulation (particularly in cars) and heaters.

The symbol

---m

determines the minimum distance from lighted objects. The minimum distance

between light-output and the illuminated surface must be more than 0.5 meters.

Make sure that the area below the installation place is blocked when rigging, derigging or servicing the

fixture.

Always fix the fixture with an appropriate safety-rope.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

No comments

EuroLite Disco Strobe 50 User Manual Page 10