EuroLite LED KLS-160 User Manual download pdf (Page 51)

00066535.DOC, Version 1.0

19/24

Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.

Insert the end in the quick link and tighten the safety screw.

The maximum drop distance must never exceed 20 cm.

A safety bond which already held the strain of a crash or which is defective must not be used again.

Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.

DANGERTOLIFE!

Beforetakingintooperationforthefirsttime,theinstallationhastobeapprovedbyanexpert!

Procedure speaker systems:

Please note: All devices, lighting effects and crossbeams attached on a stand must be secured with a

secondary attachment!

First install the LED MAT-Bar Strobe Combo on the tube via the mounting hole and tighten the fixation

screw.

Then carefully install a speaker or speaker-system with an appropriate flange on the top of the tube.

The given carrying capacity of the stand must not be exceeded. Please consult the appropriate user manual

for further information.

Caution: The loads have to be installed in a balanced way.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise

the fixtures will not work at all, or will not work properly.

Only use a DMX-cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture

or one fixture with another.

Occupation of the XLR-connection:

If you are using controllers with this occupation, you can connect the DMX-output of the controller directly

with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other

XLR-outputs, you need to use adapter-cables.

Building a serial DMX-chain:

Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always

connect one output with the input of the next fixture until all fixtures are connected.

Caution: At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120

 resistor

between Signal (–) and Signal (+) in the DMX-output of the last fixture.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 97 98

No comments

EuroLite LED KLS-160 User Manual Page 51