EuroLite TMH-155 Moving-Head User Manual download pdf (Page 30)

51786410_V_2_4.DOC

30/63

F3 - 16 Bit operation

With this function you can reduce the projector-movement to 16 bit.

• Press the Function button and select „F3“.

• Press the Up button to select “y” if you wish to enable this function or press the Down button to select “n”

if you don’t.

F4 - Demo operation

In the Stand Alone mode, the TMH-155 can be used without controller. Disconnect the TMH-155 from the

controller and call up the internal program (F4).

• Press the Function button and select „F4“.

• Press the Up button to select “y” if you wish to enable this function or press the Down button to select “n”

if you don’t.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different

occupation with different features.

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from

which the TMH-155 will respond to the controller.

Please, be sure that you don’t have any overlapping channels in order to control each TMH-155 correctly

and independently from any other fixture on the DMX data link.

If two, three or more TMH-155 are addressed similarly, they will work similarly.

Press the Up/Down-buttons for setting the desired starting address.

Controlling:

After having addressed all TMH-155, you may now start operating these via your lighting controller.

Note:

After switching on, the TMH-155 will automatically detect whether DMX 512 data is received or not. If the

data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights

up permanently.

This situation can occur if:

- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TMH-155.

- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap

in the input connector.

Note:

It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to

ensure proper transmission on the DMX data link.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 62 63

No comments

EuroLite TMH-155 Moving-Head User Manual Page 30